Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 5 1 2 3 Next » Last »
Showing results 1 to 25 of 121
Search took 0.02 seconds. Search: Posts Made By: LouZ
Forum: Porsche 996/997/991 Forum 03-24-2022, 08:45 AM
Replies: 0
Views: 865
Posted By LouZ
Looking for location of A/C Evaporator Housing Temp Sensor

My A/C compressor won't turn on, however, the 2 front fans turn on after 20 seconds and run continuously. My scanner indicates that the A/C evap sensor is reading -40 degrees. This reading prevents...
Forum: Boxster & Cayman Forum 03-23-2022, 11:26 AM
Replies: 3
Views: 1,688
Posted By LouZ
That's exactly where it SHOULD be, unfortunately,...

That's exactly where it SHOULD be, unfortunately, it is not there. I actually removed the driver side duct to see if it was just hidden from view (and touch) and that area is a solid piece of...
Forum: Boxster & Cayman Forum 03-23-2022, 09:52 AM
Replies: 3
Views: 1,688
Posted By LouZ
Looking for location of A/C Evaporator Housing Temp Switch

My 2008 Cayman S A/C compressor won't turn on, however, the 2 front fans turn on after 20 seconds and run continuously. My scanner indicates that the A/C evap sensor is reading -40 degrees. This...
Forum: Porsche 964 & 993 Technical Forum 06-30-2018, 05:33 PM
Replies: 5
Views: 907
Posted By LouZ
You DO realize that it's air cooled!!?? There is...

You DO realize that it's air cooled!!?? There is no thermostat.

The best way to lower the engine temp is to remove the undertray.
Forum: Porsche 964 & 993 Technical Forum 12-21-2015, 02:46 PM
Replies: 7
Views: 1,050
Posted By LouZ
You will need to unbolt the TC and install it...

You will need to unbolt the TC and install it (properly seated) to the tip, then bolt up the tip, followed by bolting the TC to the flywheel, through the starter hole.

If you don't do it this way,...
Forum: Porsche 964 & 993 Technical Forum 04-21-2015, 05:27 PM
Replies: 8
Views: 1,930
Posted By LouZ
Like I noted on Rennlist, check those front tires!

Like I noted on Rennlist, check those front tires!
Forum: Porsche 964 & 993 Technical Forum 07-07-2014, 11:51 AM
Replies: 3
Views: 791
Posted By LouZ
You need to plug in a jumper. Do a search to find...

You need to plug in a jumper. Do a search to find out where to get it and where it goes.
Forum: Porsche 964 & 993 Technical Forum 07-01-2014, 06:56 PM
Replies: 2
Views: 599
Posted By LouZ
No picture! I don't believe there is a C4...

No picture!

I don't believe there is a C4 Tip, only the C2. Here is the back of a Tip off of my 1990C2. You can see that there is no drive shaft extending to the front of the...
Forum: Porsche 964 & 993 Technical Forum 06-25-2014, 03:52 PM
Replies: 11
Views: 2,875
Posted By LouZ
Check your tool kit as that 12 point should be...

Check your tool kit as that 12 point should be included!
Forum: Porsche 964 & 993 Technical Forum 06-25-2014, 03:49 PM
Replies: 11
Views: 2,875
Posted By LouZ
Got it from Sunset Porsche in Oregon. They are...

Got it from Sunset Porsche in Oregon. They are the best for OEM parts. Price was around $530, including the fan hub (that part alone is over $125)
Forum: Porsche 964 & 993 Technical Forum 06-25-2014, 02:59 PM
Replies: 11
Views: 2,875
Posted By LouZ
The problem is that the fan is attached to the...

The problem is that the fan is attached to the alternator by the fan hub. The hub allows the fan to turn independent of the alternator shaft. The fan hub is a press fit to both the fan and the...
Forum: Porsche 964 & 993 Technical Forum 05-24-2014, 06:12 PM
Replies: 1
Views: 579
Posted By LouZ
That's because you have water in the engine!;)

That's because you have water in the engine!;)
Forum: Porsche 964 & 993 Technical Forum 04-19-2014, 05:25 AM
Replies: 3
Views: 857
Posted By LouZ
Here's a thread from last week, it will give you...

Here's a thread from last week, it will give you something to do while you wait.
...
Forum: Porsche 964 & 993 Technical Forum 04-16-2014, 06:50 AM
Replies: 12
Views: 2,351
Posted By LouZ
I have an Autothority hot wire MAF and K&N filter...

I have an Autothority hot wire MAF and K&N filter which replaced the barn-door. Unfortunately, this setup will not work with a stock Steve Wong chip.

I can't quantify any improvement due to the...
Forum: Porsche 964 & 993 Technical Forum 04-13-2014, 06:12 AM
Replies: 2
Views: 838
Posted By LouZ
I didn't find any torque spec either. When I...

I didn't find any torque spec either. When I reinstalled the TC, I initially threaded each one so they just held the TC on. Then I brought each one up snug. Then when back and snugged them a bit...
Forum: Porsche 964 & 993 Technical Forum 04-10-2014, 04:38 PM
Replies: 33
Views: 4,770
Posted By LouZ
No, I was lucky, engine was turning around 2000...

No, I was lucky, engine was turning around 2000 RPM, and the shroud apparently deflected it all. Blades were all over the engine, but I don't see any damage.
Forum: Porsche 964 & 993 Technical Forum 04-10-2014, 11:04 AM
Replies: 33
Views: 4,770
Posted By LouZ
Thanks Anthony (Cobalt) I'm leaning your way that...

Thanks Anthony (Cobalt) I'm leaning your way that there was an inbalance that stressed the shaft and it fatigued to failure. It was likely brought on earlier by the A/C belt episode which ruined the...
Forum: Porsche 964 & 993 Technical Forum 04-10-2014, 10:03 AM
Replies: 33
Views: 4,770
Posted By LouZ
Fan shroud is fine, a couple of minor knicks but...

Fan shroud is fine, a couple of minor knicks but that's it. How was Sunset's price, I THINK that I may need a new one.:rolleyes:

I'm sure that there was a crack on 2 blades, but, I can't be...
Forum: Porsche 964 & 993 Technical Forum 04-10-2014, 07:43 AM
Replies: 33
Views: 4,770
Posted By LouZ
Ironic! On the way to the office this...

Ironic! On the way to the office this morning.....BAM! I sheared the Alt shaft right off. I don't know if the fan blade broke, got stuck and stressed the shaft, or if the shaft snapped and then the...
Forum: Porsche 964 & 993 Technical Forum 03-30-2014, 10:38 AM
Replies: 83
Views: 6,573
Posted By LouZ
Used the Torx socket on my 20V portable impact...

Used the Torx socket on my 20V portable impact gun.
Forum: Porsche 964 & 993 Technical Forum 03-27-2014, 04:14 AM
Replies: 83
Views: 6,573
Posted By LouZ
The 964 TIP has bolts holding the tranny to the...

The 964 TIP has bolts holding the tranny to the engine. We grabbed a few studs from an early 911 to mount the engine to the yolk. You will need to find the correct bolt length, or a bunch of washers...
Forum: Porsche 964 & 993 Technical Forum 03-23-2014, 02:07 PM
Replies: 83
Views: 6,573
Posted By LouZ
Removed TIP and left the TC attached to the...

Removed TIP and left the TC attached to the plate.http://forums.pelicanparts.com/uploads22/image1395608815.jpg
Forum: Porsche 964 & 993 Technical Forum 03-23-2014, 08:06 AM
Replies: 83
Views: 6,573
Posted By LouZ
The HE hides a tranny bolt. I have removed the...

The HE hides a tranny bolt. I have removed the bolt WHILE THE ENGINE IS IN THE CAR. Since it is out, remove the HE now, so you can get to the bolt.
Forum: Porsche 964 & 993 Technical Forum 03-19-2014, 09:22 AM
Replies: 83
Views: 6,573
Posted By LouZ
It all has to come off to mount the yolk.

It all has to come off to mount the yolk.
Forum: Porsche 964 & 993 Technical Forum 03-18-2014, 02:08 PM
Replies: 83
Views: 6,573
Posted By LouZ
If you have the tool, then it will keep the TC...

If you have the tool, then it will keep the TC attached to the tranny shaft. But you will have to unbolt the TC thru the starter hole as you first asked.

I pulled the TC off of the shaft to...
Showing results 1 to 25 of 121
Page 1 of 5 1 2 3 Next » Last »

 
Forum Jump

All times are GMT -8. The time now is 02:20 PM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.