|
|
|
|
| Author |
|
|
Registered
Join Date: Oct 2006
Location: Boulder, CO
Posts: 150
|
Temp sensor(s) for CSV
The PET shows two sensors, one on each side of the engine, is this the case? In my SC there is just one sensor, on the driver's side. I want to at least temporarily disable my cold-start valve, which again in the SC you can do by pulling a wire at the sensor. I know I can pull the wire at the CSV but it's not too easily accessed. Thanks.
__________________
'01 996, w/ LN IMS! Past: '96 993, '98 986, '82 911, '99 986, '87 930, '86 951, '85 911 GTS3 race car |
||
01-31-2009, 06:14 PM
|
|
|
Registered
Join Date: Oct 2006
Location: Boulder, CO
Posts: 150
|
Don't everyone answer at once!
 I found I could just pull the wire from the CSV. Much easier in the turbo than the SC (impossible without dropping the engine), especially with the stock airbox assembly gone.
__________________
'01 996, w/ LN IMS! Past: '96 993, '98 986, '82 911, '99 986, '87 930, '86 951, '85 911 GTS3 race car |
||
|
02-02-2009, 11:10 AM
|
|
