anyone have a source for a 41mm crowsfoot

[edbaus]

Hi,

I am looking for a 41mm crowsfoot wrench to tighten the nut on the camshafts of my motor.

Yes, I know the standard is 46, but I have a set of racing cams from the 70's that use the 41mm like it shows in Bruces book,

Or, does any one have one that I can rent for a week.

THanks

Ed

[mudman]

I bought a set of big feet from www.thetoolwarehouse.net , they were cheap, $70 I think for a 17pc set, 20mm - 46mm. Not the highest quality but not bad for a big set...
-Jeremy

[Henry Schmidt]

Here's how we remedied the problem for 906 cams.

[edbaus]

Sounds good to me. Done that in the past.

Thanks Henry.

Ed

[MBEngineering]

HI the tool you are looking for (if any one will LEND you it) is 000.721.139.00 of which is no longer aval' from porsche as i only asked on the 31 of last month, it is stamped P139, if you do not sort the spanner job out PM me and i might just let you borrow mine??

regards mike