Need a little engine room help

[K9Torro]

Hi

Can anyone take a look at the pic below, and tell me what hose I am missing that connects where the red arrow is drawn to that large round opening coming off the fan shroud, and where it is supposed to go ?

Thanks in advance,

Todd

[DonMo]

Through the engine tin to the heater duct on the heat exchanger. It is your heat.

[svandamme]

hot air blower and tubing

[K9Torro]

Hi

Thanks for the help, my car does not have heat, the PO took put on a aftermarket exhaust and it uses the open tube design headers, any idea on what else I could use this for?

Todd

[svandamme]

just make sure it's plugged up or you loose cooling
the right side has a blocking plate , but the left side doesn't

unless it's plugged inside the socket , the fan will blow through that hole , instead off blowing over your heads and cyllinders

[svandamme]

PP sells block off plates
you have the right one , migt get the left one , not expensive
made out of plastic , see the one on my engine

all you need to do is unbolt the old hot air socket
drill a hole in the new plastic one
and bolt it in place