|
|
|
|
| Author |
|
|
Registered
Join Date: Dec 2006
Location: Boston, MA
Posts: 87
|
Help with '67 flasher unit!?
I've got a '67 912 and the turn signals won't blink. I replaced the flasher unit, which was an elusive 5 pronged experience (with spade fittings, not a plug-in unit).
It has two independent terminals at one end, a common-two pronged terminal in the middle, and a single terminal at the other end. The wiring diagrams I have looked at show only three wires (of completely different colors than what's in my car) going into a unit and the terminals have different numbers on the diagram. Anyone have this experience and know what I should plug in where? I have a red wire carrying 12volts with a siamesed red coming off of it, and a brown ground wire as well as two others of varying stripes. ANY AND ALL ADVICE WELCOME! Cheers, Nick |
||
08-21-2007, 08:30 PM
|
|
|
Moderator
Join Date: Dec 2001
Posts: 9,569
|
Nick,
Been there, done that, reverse-engineered it! See here and post your questions on the below thread. Need advice - "Blinker" (Hazard) Control Unit early 901
__________________
'66 911 #304065 Irischgruen ‘96 993 Carrera 2 Polarsilber '81 R65 Ex-'71 911 PCA C-Stock Club Racer #806 (Sold 5/15/13) Ex-'88 Carrera (Sold 3/29/02) Ex-'91 Carrera 2 Cabriolet (Sold 8/20/04) Ex-'89 944 Turbo S (Sold 8/21/20) |
||
|
08-21-2007, 09:45 PM
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
