|
|
|
|
| Author |
|
|
Registered
Join Date: Nov 2007
Location: Oslo, Norway
Posts: 18
|
Pertronix Ignitor
Hi.
Some days ago i was planning on mounting the Pertronix Ignitor Electronic Ignition on my 1972 911E 2.4 EFI. I bought PEL-PT1863 as i thought it would fit my car. When i was reading the instructions it stood that this kit only could be used on coils with more than 1,5 ohms. I measured my coil to 0,7 ohms. Could i still use this kit on my engine, or do i need to modify something? Iam also wondering if my engine has a ballast resistor? I can only see that the - wire goes to the engine and the + wire goes to the ignition unit.. |
||
11-11-2007, 06:51 AM
|
|
|
Registered
Join Date: Nov 2007
Location: Oslo, Norway
Posts: 18
|
Bump!
I tryed the search function, but did not get any help there.. |
||
|
11-12-2007, 12:00 PM
|
|
|
Registered
Join Date: Jun 2006
Location: Adelaide Australia
Posts: 886
|
911 Oslo
I installed the same model on my 2.4 engine with S dizzy, and black coil and it runs fine. Give it a try, I think you will be ok. Good luck
__________________
'74 RS 3.0 Replica Porsche 968 Clubsport SOLD '70 911E Bahia Red SOLD '71 911 S/T Replica 2.3 Twin plug BEAST  SOLD
|
||
|
11-13-2007, 12:12 AM
|
|
