![]() |
|
|
|
Registered
|
Dashboard Heater Conrol Panel
Planning to replace the 4 lights behind the control panel due to their excess heat that has disfigured the 4 mounting holes
I would like to replace them with a new wiring harness with (4) 12 volt clear LED assemblies. I checked with Radio Shack and found colored 12 volt LED assemblies but no Clear Does anyone have a source for the 12 volt Clear LED assemblies? Many Thanks, Bill 1979 Targa ![]() |
||
![]() |
|
Registered
Join Date: Aug 2008
Location: sectors R&N, SE Pa
Posts: 3,117
|
Just LED's? - maybe Digikey?
Not sure I follow the application, but I saw some thread regarding illuminated tape or in dash LEDs where they recommended 4 leds per original lamp (as in 16) in the case of clear color.
__________________
Dan '87 Targa Carrera 3.2 - Fabspeed Cat Bypass, M&K Muffler, SW Chip Venetian Blue |
||
![]() |
|
Registered
|
![]()
The 'mounting holes' are a part of the panel so you pretty much have to replace the whole panel to fix it. Maybe there is a way to rig something aftermarket, I dunno?
I just replace the panel in my -84. The job wasn't all that bad. Lucked out and found a good used panel in the parts FS section... jt |
||
![]() |
|
Member 911 Anonymous
|
__________________
'85 Carrera Targa Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace PCA/POC Last edited by DRACO A5OG; 07-21-2009 at 07:22 PM.. |
||
![]() |
|
muck-raker
Join Date: Jan 2009
Location: Coastal PNW
Posts: 3,059
|
Dude, are you stripping your Targa bar, or was it already stripped?
Whatever you're doing, keep it up...it looks saweeet.
__________________
STONE '88 Cabriolet, using EP Slick 20w50 partial synthetic Snake Oil...just as Rommel intended. ![]() Deny Everything; Admit Nothing; and Always Make Counter-accusations ![]() |
||
![]() |
|