|
|
|
|
| Author |
|
|
porsher
|
O2 sensor rewire
I have a new O2 sensor 928-606-124-00-M14 with two connectors.
I actually need a one connector type 965-606-126-01-M14 Can I cut the connector off my old sensor and reterminate the wires onto the new (wrong) sensor? If so, which wires go where? TIA
__________________
86 911 Race Car, with a few 993 bits in the boiler room 79 928 Race Car 88 928 Becoming a Race Car |
||
01-01-2011, 10:33 AM
|
|
|
Registered
Join Date: Aug 2008
Location: San Francisco, CA.
Posts: 603
|
Either checker or Bap have a generic Bosch o2 sensor for $20. Bosch sensors with connectors are typically around $70. I wouldn't cut it and return it.
I've been using the twenty dollar ones and they are great. Good luck Chris |
||
|
01-01-2011, 11:08 PM
|
|
|
Registered
|
the black wire is the sensor the two white wires are heater for the sensor.
Hope this helps. Louie
__________________
91 964 Guards Red 64 356C Ruby Red 85 Carrera (Gone but not forgotten) |
||
|
01-02-2011, 06:11 PM
|
|
|
porsher
|
I have discovered that Bosch make universal sensors that can be spliced into existing wiring.
I think this is a good indication that splicing the old connector will be OK. Here's a link to the installation instructions. http://www.clarks-garage.com/shop-manual/OxygenSensorInstall.pdf
__________________
86 911 Race Car, with a few 993 bits in the boiler room 79 928 Race Car 88 928 Becoming a Race Car |
||
|
01-02-2011, 07:25 PM
|
|
