Pertronix Ignitor not working with MSD 6A

[cdomingos170]

I bought an Ignitor Electronic Ignition (2862), on Pelican Parts Site to install on my Porsche 911T (year:1969).
My car has a MSD 6A ignition kit installed (installation scheme attached).



After reading your instructions manual (attached also) I installed it putting:

1. Ignitor black wire to original distributor green wire (that goes through MSD to Coil Negative)
2. Ignitor Red Wire Directly to Coil Positive



… and the motor do not run. I try other several ways and nothing!
I take out the ignitor and put back the points and it is all ok again.

What should I do?

Regards,
Carlos Domingos
Portugal (Europe)

[cdomingos170]

seeing the drawings again...
I will try:

- Pertronix Ignitor Black wire >>> original Green wire > MSD White Wire
- Pertronix Ignitor Red wire >>>MSD Red wire