![]() |
|
|
|
Registered
Join Date: Jun 2003
Location: Fresno, CA
Posts: 7,751
|
How to install an oxygen sensor bung on SSI?
I need to add an oxygen sensor to my SSI's. My current SSI's do not have the bung installed.
Does anyone have a photo that shows the proper placement? Any specific measurements would be hepful as well (i.e., xx inches from flange, etc..). Lastly, I cannot find a weld-on bung for sale on the Pelican site. My maintenance guy at work (who tig-welds stainless all the time, says that he has what I need and he say that the bungs he has are heavier duty that what I will find out there). Any comments from the Pelican Brain Trust on this? Thanks for any and all advice. I need to get this done for my electromotive engine management that I will be installing at the end of the month. |
||
![]() |
|
ROW '78 911 Targa
|
Second picture in my thread here shows where I put mine.
No measurements, sorry. Finally, back in the game! Bought a stainless bung on Ebay.
__________________
Dennis Euro 1978 SC Targa, SSI's, Dansk 2/1, PMO ITBs, Electric A/C Need a New Wiring Harness? PM or e-mail me. Search for "harnesses" in the classifieds. |
||
![]() |
|
muck-raker
Join Date: Jan 2009
Location: Coastal PNW
Posts: 3,059
|
I have a 3.2, and just measured 9" from the center of the bung to the flange. It was installed on my SSI when I purchased the vehicle.
__________________
STONE '88 Cabriolet, using EP Slick 20w50 partial synthetic Snake Oil...just as Rommel intended. ![]() Deny Everything; Admit Nothing; and Always Make Counter-accusations ![]() |
||
![]() |
|
Registered
Join Date: Jun 2003
Location: Fresno, CA
Posts: 7,751
|
Perfect!
Thanks for the photos and the measurements. This is exactly what I has hoping for. |
||
![]() |
|
Banned
Join Date: Nov 2007
Location: Rockwall, Texas
Posts: 8,559
|
Quote:
Porsche 911 (1974-1989) - Engine Miscellaneous - Page 9 |
||
![]() |
|
Registered
Join Date: Jun 2003
Location: Fresno, CA
Posts: 7,751
|
Quote:
|
||
![]() |
|
![]() |
ROW '78 911 Targa
|
Quote:
If you type bung into the search you also find a stainless bung from Innovate.
__________________
Dennis Euro 1978 SC Targa, SSI's, Dansk 2/1, PMO ITBs, Electric A/C Need a New Wiring Harness? PM or e-mail me. Search for "harnesses" in the classifieds. |
||
![]() |
|
Registered
|
Perfect timing, I'm doing this as well. Thx.
__________________
Its easier asking dumb questions than fixing dumb mistakes 1974 Porsche 911 Coupe, RSR Project 1976 Porsche 911 Targa, Black 1986 Porsche 911 Carrera, Black 2006 Porsche Cayenne S, Black |
||
![]() |
|
Registered
|
I welded mine on the in-pipe for the muffler - works fine and not stainless steel.
__________________
Chris '75 911s 3.2 - Ice Green Metallic ‘87 951, '05 987 S '21 Jeep Gladiator ‘18 Tesla ModelX 100D, ‘20 Model 3 |
||
![]() |
|