|
|
|
|
| Author |
|
|
911 carrera 3.2 (1985)
Join Date: Sep 2001
Location: Harmelen, the Netherlands
Posts: 741
|
Front seat installing 911 1985
I want to re-install the front seats in my Porsche 911 1985. Does it matter whether the beveled edge of the threaded plate is facing up or down or point to the front or the back?
Maybe a stupid question, but why is it beveled? Thanks, Kees   
|
||
10-01-2016, 12:29 AM
|
|
|
Registered
Join Date: Jan 2007
Posts: 11,758
|
Someone put a piece of bar stock in a machine that sheared off a chunk. That makes it a dinosaur, an ancient relic of the past.
|
||
|
10-01-2016, 03:37 AM
|
|
|
Member 911 Anonymous
|
No, it does not matter but if you want to pass concours, beveled should face down, flat portion on the rail.
__________________
'85 Carrera Targa Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace PCA/POC |
||
|
10-01-2016, 07:26 AM
|
|
|
911 carrera 3.2 (1985)
Join Date: Sep 2001
Location: Harmelen, the Netherlands
Posts: 741
|
Thank you.
Bevel to the front or to the back 
|
||
|
10-01-2016, 08:32 AM
|
|
|
Member 911 Anonymous
|
outer edge or each facing outward to gain 000.5 hp :-P
__________________
'85 Carrera Targa Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace PCA/POC |
||
|
10-01-2016, 08:53 AM
|
|
Marble Grey
