How do I install these?

[93097004xx]

I’m asking how do I remove the old ones without breaking the levers they are attached to?




Sent from my iPhone using Tapatalk

[rwest]

They just pull off- friction fit; don't bend side to side.

[93097004xx]

Tried this but they are on tight worry about breaking the levers.


Sent from my iPhone using Tapatalk

[sugarwood]

Heat gun gentle?

[aread]

Originally Posted by sugarwood

Heat gun gentle?

Yup, heat gun worked them loose for me. Low, low heat.

[Flojo]

Originally Posted by sugarwood

Heat gun gentle?

NO!
heats up way to fast and hot! even gentle.
use a hair drier and then some wood to hammer off from backside gently.

[tcar]

Put a pair of vise grips on the backside, snug but not tight.

Gently tap the grips with a small hammer.

Did not need heat.

[93097004xx]

Go it off! Taped it off a few times to keep from damaging it the pulled off with pliers.

Then found this..

It was installed upside down.. it has faded just on the side it was installed.

So debating on whether to install the new one or try to refurbish the original.

[tcar]

Refurbish is easy.

Pan of hot RIT red dye for a couple hours.

Use white-out in the recesses, it's latex paint. wipe off the excess.