Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Porsche Forums > Porsche 912 Technical Forum


Reply
 
LinkBack Thread Tools Rate Thread
Author
Thread Post New Thread    Reply
Registered User
 
Join Date: Apr 2015
Posts: 1
912 engine assembly-sealing third piece

In assembling the third piece on a 912, there is a paper gasket which is used between the case and the third piece. In addition, there are 4 seals...2 which go between 3rd piece and the left case side, an additional smaller seal just above the crankshaft gear and then there is a seal that seals the oil collection tube from the bottom of the crankcase to the oil pump. this is the one I am concerned with. Gasket kit comes with four .9 inch (.145 diameter) o rings. Seems inadequate. Seems small and although critical since if this tube is not sealed properly, oil pump would be sucking air. any thoughts or advice. Are these the correct seals?
Old 08-18-2018, 09:11 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)
Reply

Thread Tools
Rate This Thread
Rate This Thread:

 


All times are GMT -8. The time now is 03:31 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.