|
|
|
|
| Author |
|
|
Registered
Join Date: May 2005
Location: St.Louis Metro Area
Posts: 56
|
unknown connector????where to plug it!!!
Hello
I'm little lost here , few days ago i swapped the motor in my 924 and ( new donor came from 87 944) and next to the firewall ,on the back of the engine head is unused connector .Its a 3 lead round connector attached to the rear engine lift point. Its similar in look to the o2 sensor plug . I don't see where it should be plug too. I'm little lost , i don't have diagrams neither manual .. did some search but not much luck . Thank you in advanced . Dan
__________________
84 928 , grrr, love and hate 87' 924s sold  88' 944 track project 951 R.I.P. it was a great friendship |
||
07-19-2007, 07:35 AM
|
|
|
Registered
Join Date: Jul 2004
Location: Upstate New York
Posts: 3,275
|
Its a connector for the TDC sensor that was used back in the 80s with a shop oscilloscope. Ignore it (unless you have a large shop oscilloscope and need a trigger signal.)
__________________
Good luck, George Beuselinck |
||
|
07-19-2007, 07:59 AM
|
|
|
Registered
Join Date: May 2005
Location: St.Louis Metro Area
Posts: 56
|
thank you much sir. Not planning to analyze it with oscilloscope
 hehe . Thank you for help Dan p.s.lots of useful info on your site
__________________
84 928 , grrr, love and hate 87' 924s sold 88' 944 track project 951 R.I.P. it was a great friendship |
||
|
07-19-2007, 08:18 AM
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
