|
|
|
|
| Author |
|
|
Registered
|
WTB: '85 944 N/A oil hose assembly
My 944 race car has an oil breather valve (blue cap in the attached photo). For some unknown reason last track day it started spewing oil out of it like crazy. My mechanic recommended that I go back to the stock oil hose assembly which runs under the intake manifold. I have looked thru the 944 engine diagram (see link below) but can't figure what part #s I need.
http://www.porsche.com/all/media/pdf/originalparts/en/E_944_85_KATALOG.pdf Do any of you guys happen to know where to find these parts locally? I want the car to be ready by June 8th. I am located near Provo Utah. Thanks in advance. 
__________________
PorscheOtto 85.5 944 Spec Racer 2000 Yellow Boxster 1998 Midnight Blue Boxster - Sold but not forgotten |
||
05-28-2009, 10:52 AM
|
|
|
Greasy Member
Join Date: Mar 2006
Location: Indiana
Posts: 1,457
|
That would be the "low pressure" port on the Air / oil separator. There is usually a hose that goes from the top of there to the j-boot.
If you are getting oil out of there, there is probably too much oil in the crankcase! On a couple of occasions at the track, we have had cars vomit oil up through there into the j-boot... Everytime, they have been over-filled with oil. Removing enough oil to bring the level to "full" resolves the problem. If that doesn't resolve your issue, drop me a PM, I probably have a couple spares lying around the race trailer. -Nick
__________________
Owner: Bennington Motorsports www.benms.com Sponsor for Midwest Region 944-SPEC racing series -When was your timing belt changed or tensioned?? -Yes, I'm the crazy man that will loan out my 9201. Just PM me, I will add you to the list and get it out ASAP. |
||
|
05-29-2009, 05:17 AM
|
|
944 Spec Racer
