|
|
|
|
| Author |
|
|
Registered
Join Date: Jun 2003
Posts: 38
|
cab elec top problem
hi all,
my elec top isnt working,hoping for some suggestions please. i had to lower the roof manually. i pulled the switch and i have power at 1 of the 3 wires. when removing switch the 3 wires came of the switch. can anybody assist with wiring diagram for the 3 wires to the switch. should there only be power at 1 of the 3 wires. any suggestions of what to check next. thanks Dean |
||
11-08-2003, 04:23 AM
|
|
|
Registered
Join Date: Feb 2001
Location: Viera FL
Posts: 5,642
|
THe center wire should be "hot", then the switch position determines which way the motors run.
Couple of things to check: Check the relay Make sure the microswitches on the transmission (Passenger side, drivers in UK\AUS) are not triggered - if the little "feet" get out of alignment and lits the upper switch, it cuts all power to the top. AFJuvat
__________________
Es geht nicht darum wie schnell man faehrt, sondern wie gut man schnell fahren kann. Ihr Brunnen der nutzlosen Porsche Information |
||
|
11-08-2003, 05:42 PM
|
|
|
Registered
Join Date: Jun 2003
Posts: 38
|
hi afjuvat,
so on the switch as long as the hot wire is centre pin the other 2 wires dont really matter,switch will operate around the wrong way if the other 2 wires are switched around. what do u mean about transmission ,where is it located exactly please. |
||
|
11-08-2003, 06:09 PM
|
|
