|
|
|
|
| Author |
|
|
Registered
Join Date: May 2005
Location: Eastern Pa.
Posts: 679
|
Spanner size for rear e height adjust.
Two part question
1) How much ride height range is there by loosening the torison bar plate bolt and eccentric bolt. 2) What is the size of the spanner I need to adjust the large eccentric bolt on the inside of the plate?? Thanks
__________________
HB Kramer (4 sneaks and 6 airheads): 79 911SC Coupe (sunroof delete) (2 sneaks and 2 airheads): BMWS: R12GS(a) R90S, and some old British iron as well. |
||
09-26-2005, 08:21 AM
|
|
|
Formerly bb80sc
Join Date: Aug 2001
Location: Hollywood Beach, CA
Posts: 4,361
|
1. You should be able to get 1/2-3/4 either way adjusting the eccentric. This will raise/lower the car, but will upset the balance if has been set.
2. 36mm, go you your local bike shop and buy a thin 36mm head wrench -B
__________________
Cheers -Brad 2015 Cayman GTS 2015 4Runner Limited |
||
|
09-26-2005, 09:04 AM
|
|
|
Registered
Join Date: May 2005
Location: Eastern Pa.
Posts: 679
|
Thanks appreciated.
,as well as input on coner bal. i doubt it has been set,so I will adjust with the eccentric first. Maybe a corner balance for Christmas.after SSI and Chain Tensioner install
__________________
HB Kramer (4 sneaks and 6 airheads): 79 911SC Coupe (sunroof delete) (2 sneaks and 2 airheads): BMWS: R12GS(a) R90S, and some old British iron as well. |
||
|
09-26-2005, 09:51 AM
|
|
