![]() |
|
|
|
Registered
Join Date: Dec 2005
Location: Bay Area, Ca
Posts: 877
|
1st time removing an engine, any advice..
This will be the first time I remove an engine from a car (79SC). I've already gone over Wayne's book as well as the tech article on Pelican. Just wondering if anyone can offer any suggestions on what I should look out for, and what I should replace while the engine is out. Planning on putting the EGR on, valve adjustment, and check for leaks.
Thanks |
||
![]() |
|
Registered
|
I found it easier to remove the rear bumper, you won't have to jack up the back end as high. Only takes 15 minutes, worth the time.
__________________
1983 911 SC 2015 Volks GTI 1991 Volks GTI 2011 Nissan Juke 1992 Nissan NX 2000 |
||
![]() |
|
Registered
Join Date: Dec 2004
Location: Suwanee, GA
Posts: 690
|
oil temp sender gasket.
oil cooler gasket brass fittings for your pedal linkage check and replace clutch/ fork/ etc. replace fluid as well. a few more I can't think of right now.
__________________
1982 Porsche 911SC Coupe - Factory Short Shift |7:31 R&P in AL case | Toyo RA1 Tires | Corbeau TRS seats | M&K 2 in 2 out muffler |
||
![]() |
|