![]() |
|
|
|
TIG Welder
|
Question on installing tensioner collars
I tried searching for up to a minute with no luck
![]() I am installing the safety collars on my SC's mechanical chain tensioners. The instructions say to rotate the engine 360 degrees. When I try to turn the engine over using a breaker bar, the alternator belt is slipping (belt is new and recently installed by my mechanic.) Tranny is in neutral. Do I need to pull a spark plug, or what? Jason
__________________
'79 SC Targa (SOLD) '85 944 (SOLD) '86 951 (SOLD) '97 Boxster (SOLD) |
||
![]() |
|
Senior Advisor
|
Well no, just turn slow and in the correct way. push in on the belt while turning the wrench. should spin right over. You can here the air leak out between turns. Also, check the belt tension while your in there. (and cam timing, and valve clearance, and new gaskets, and new locknuts.....) It never ends
__________________
08 Cayenne Turbo |
||
![]() |
|
Registered
|
Jason:
You can place a finger on the alternator belt, right-side, as you apply force with your breaker-bar and it should turn. If the belt still slips, then it must be on too loose. You can remove a shim from between pulleys to compensate and make the belt tighter, a little tricky, so try above first. Just my .02 cents. Good luck.
__________________
Ed Paquette 1983 911SC 1987 944S 1987 944 Manual (Donated to the Nat. Kidney Foundation) 1987 944 Automatic (Recently sold to another Pelican) |
||
![]() |
|
Senior Advisor
|
good $0.02
__________________
08 Cayenne Turbo |
||
![]() |
|
TIG Welder
|
Awesome, thanks guys. I'll give that a try in the morning!
__________________
'79 SC Targa (SOLD) '85 944 (SOLD) '86 951 (SOLD) '97 Boxster (SOLD) |
||
![]() |
|
Registered
|
Thanks, James!
we must have been reading, thinking and posting at the same time.
__________________
Ed Paquette 1983 911SC 1987 944S 1987 944 Manual (Donated to the Nat. Kidney Foundation) 1987 944 Automatic (Recently sold to another Pelican) |
||
![]() |
|
![]() |
Senior Advisor
|
MORNING! morning is for tea and crumpets, get back out to the garage and finish that job and drive!
__________________
08 Cayenne Turbo |
||
![]() |
|
TIG Welder
|
Good point! If this was all that was keeping me from turning the key I'd stay out there all night... Have quite a few little projects going on!
__________________
'79 SC Targa (SOLD) '85 944 (SOLD) '86 951 (SOLD) '97 Boxster (SOLD) |
||
![]() |
|