Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 5 1 2 3 Next » Last »
Showing results 1 to 25 of 104
Search took 0.02 seconds. Search: Posts Made By: BCLi
Forum: Porsche 911 Technical Forum 10-11-2022, 03:43 PM
Replies: 541
Views: 41,699
Posted By BCLi
Awesome. Wonderful if you can fabricate the NLA...

Awesome. Wonderful if you can fabricate the NLA parts.
Forum: Porsche 911 Technical Forum 09-14-2022, 09:34 AM
Replies: 541
Views: 41,699
Posted By BCLi
So I did what Julian suggested - put a large(r)...

So I did what Julian suggested - put a large(r) manifold connection to get as much signal for the MAP. The IAC from my understanding acts as a small input of air, similar to the hand throttle, and...
Forum: Porsche 911 Technical Forum 09-13-2022, 07:07 AM
Replies: 541
Views: 41,699
Posted By BCLi
I was lucky in that I could design my system that...

I was lucky in that I could design my system that had all of the vacuum lines connected into the same manifold, including the ITBs and the IAC. That being said, I actually capped off the IAC line...
Forum: Porsche 911 Technical Forum 09-12-2022, 08:54 AM
Replies: 541
Views: 41,699
Posted By BCLi
Thanks Al, Julien and Rutager - I'll have to try...

Thanks Al, Julien and Rutager - I'll have to try to create a table of my own and see how it matches to your values.
Forum: Porsche 911 Technical Forum 09-12-2022, 08:50 AM
Replies: 541
Views: 41,699
Posted By BCLi
I'd be interested in hearing how that goes. I've...

I'd be interested in hearing how that goes. I've had another driver in the car while I monitor the computer and with the exception of a lean spike momentarily, it stays around 15 for the most part. ...
Forum: Porsche 911 Technical Forum 09-03-2022, 03:47 PM
Replies: 541
Views: 41,699
Posted By BCLi
I think I have a GM temp sensor, but am not sure...

I think I have a GM temp sensor, but am not sure about that - no harm in doing some calibration as needed, though (maybe Al can comment on that since he sold it to me). I've balanced the ITBs a...
Forum: Porsche 911 Technical Forum 09-03-2022, 11:58 AM
Replies: 541
Views: 41,699
Posted By BCLi
I didn't calibrate it since I didn't think of it....

I didn't calibrate it since I didn't think of it. That's another thing on the to do list. Thanks for suggesting it - I actually think my ECU coolant temp is more accurate than my gauge temp, but...
Forum: Porsche 911 Technical Forum 09-03-2022, 10:52 AM
Replies: 541
Views: 41,699
Posted By BCLi
Al was kind enough to refer me to another type of...

Al was kind enough to refer me to another type of timing light, which I have been calling around to try to rent to see if it is less influenced by wasted spark.
Also did try my Innova 3551 (pretty...
Forum: Porsche 911 Technical Forum 09-03-2022, 10:37 AM
Replies: 541
Views: 41,699
Posted By BCLi
I definitely understand. While the gauge...

I definitely understand. While the gauge thermometer on my car reads above 210 degrees F, the 'coolant' input from the megasquirt was reading 240 degrees F + and giving me a nasty scary warning...
Forum: Porsche 911 Technical Forum 09-03-2022, 10:24 AM
Replies: 541
Views: 41,699
Posted By BCLi
Well, the good news is that you're making...

Well, the good news is that you're making progress! It's great how you're getting the cells filled in as much as possible - I have done something similar, but going both vertically and horizontally...
Forum: Porsche 911 Technical Forum 08-31-2022, 06:46 AM
Replies: 541
Views: 41,699
Posted By BCLi
That truly is fantastic. You are more dedicated...

That truly is fantastic. You are more dedicated to the details than I am - I left the tins alone as well as the shroud. But I did put in a cooler, since there was no trombone or other cooler - just...
Forum: Porsche 911 Technical Forum 08-30-2022, 04:06 PM
Replies: 541
Views: 41,699
Posted By BCLi
Great news! Did you end up putting back the...

Great news! Did you end up putting back the cooler you had in, that goes under the engine?
Forum: Porsche 911 Technical Forum 08-30-2022, 02:25 PM
Replies: 541
Views: 41,699
Posted By BCLi
Hi Al: Yes, this is exactly the way I did it,...

Hi Al:
Yes, this is exactly the way I did it, based on our conversations which seem so long ago. I did check the initial timing for synch at TDC at tooth one, but after setting it to use table and...
Forum: Porsche 911 Technical Forum 08-30-2022, 07:01 AM
Replies: 541
Views: 41,699
Posted By BCLi
Thanks - I will try this as well! Bert

Thanks - I will try this as well!
Bert
Forum: Porsche 911 Technical Forum 08-30-2022, 07:00 AM
Replies: 541
Views: 41,699
Posted By BCLi
Yes - thanks Al - I made that spark plug...

Yes - thanks Al - I made that spark plug extender. But I have read that timing is suspect using this - will check again, since I could be misinterpreting this. Much appreciate.
Best,
Bert
Forum: Porsche 911 Technical Forum 08-29-2022, 03:14 PM
Replies: 541
Views: 41,699
Posted By BCLi
Thanks Rutager. With the COP, to measure timing...

Thanks Rutager. With the COP, to measure timing I have to set it up with an attachment that goes into the spark tube to assess - but I too have read that electronic ignitions don't measure timing...
Forum: Porsche 911 Technical Forum 08-29-2022, 06:08 AM
Replies: 541
Views: 41,699
Posted By BCLi
Thanks Rutager. I believe in the MS II, the SAW...

Thanks Rutager. I believe in the MS II, the SAW output comes from pin 17 on the main board, but I don't know where it comes from in the MS3 - can you help me on that? As well, are you running...
Forum: Porsche 911 Technical Forum 08-28-2022, 05:47 PM
Replies: 541
Views: 41,699
Posted By BCLi
Wow - great to hear, Rutager! I'm curious how...

Wow - great to hear, Rutager! I'm curious how you figured out that you weren't advancing - what symptoms did you have? I haven't trusted my timing light since the get go, for the same reasons you...
Forum: Porsche 911 Technical Forum 06-27-2022, 02:56 PM
Replies: 541
Views: 41,699
Posted By BCLi
Yes, in my old Piper Saratoga (plane), the rule...

Yes, in my old Piper Saratoga (plane), the rule of thumb was to run rich to cool the engine. But I think all bets are off when we change the intake and 'efficiency' (read work) of the engine due to...
Forum: Porsche 911 Technical Forum 06-27-2022, 12:46 PM
Replies: 541
Views: 41,699
Posted By BCLi
Interesting. Since the conversion, my engine...

Interesting. Since the conversion, my engine also is definitely running hotter than it did before. I don't have any other cooler either, so have been watching this on my drives. I didn't put on my...
Forum: Porsche 911 Technical Forum 06-03-2022, 06:42 AM
Replies: 541
Views: 41,699
Posted By BCLi
Fantastic! Congrats!

Fantastic! Congrats!
Forum: Porsche 911 Technical Forum 06-02-2022, 06:51 AM
Replies: 541
Views: 41,699
Posted By BCLi
Thanks for all your help, Al. BTW, I only have...

Thanks for all your help, Al. BTW, I only have single plugs. It was a steep learning curve (and continuing) but well worth it.
Forum: Porsche 911 Technical Forum 05-14-2022, 12:26 PM
Replies: 541
Views: 41,699
Posted By BCLi
Great progress! Happy to hear you're on the...

Great progress! Happy to hear you're on the road. Have the same light backfires on deceleration, and have been talking with a relatively local mechanic on my AFR tables. Look forward to hearing on...
Forum: Porsche 911 Technical Forum 12-26-2021, 10:04 AM
Replies: 541
Views: 41,699
Posted By BCLi
That's great, Rutager. Very clever. I've got...

That's great, Rutager. Very clever. I've got all of my vacuum lines into one 'manifold' since I don't run my MAP separately. I too have the experience initially of getting a 'kick' above 4000 RPM,...
Forum: Porsche 911 Technical Forum 12-06-2021, 10:22 AM
Replies: 541
Views: 41,699
Posted By BCLi
Congrats Rutager - have been off line for awhile...

Congrats Rutager - have been off line for awhile pushing to get all the bugs sorted out. Heath exchangers deleted so when I saw what you're going through, I was happy about that. I got my ITB'ed...
Showing results 1 to 25 of 104
Page 1 of 5 1 2 3 Next » Last »

 
Forum Jump

All times are GMT -8. The time now is 05:38 AM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.