Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Porsche Forums > 911 Engine Rebuilding Forum


Reply
 
LinkBack Thread Tools Rate Thread
Author
Thread Post New Thread    Reply
Registered User
 
Join Date: Sep 2002
Location: Tulsa, OK
Posts: 116
Cam Tower Can Bearing Surface

1972 2.4T Build....or should I say pre-build...

1.) Is this normal surface wear on the cam bearing surface?

2.) What is the purpose of this small pin? (if it is a pinů)





Old 03-18-2019, 12:06 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)
Registered User
 
Walt Fricke's Avatar
 
Join Date: May 2004
Location: Boulder, Colorado
Posts: 5,233
It doesn't look bad to me, but others may have other views.

The "pin" is a plug for the drilling which takes the lubricating oil from the spray bar (assuming it is installed with the correct orientation) into the bearing below. If you stick a finger into the bearing area you can feel the hole.
Old 03-18-2019, 12:15 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #2 (permalink)
Reply

Thread Tools
Rate This Thread
Rate This Thread:

 


All times are GMT -8. The time now is 08:52 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.