Thanks Arne!

Yes, we've already made a 3.4 badge Techweenie. We can make any set of numbers, and more, that you want.

Arne, I didn't think of this, but would you please verify the description of the 11.5? Is that measuring outside to outside, center to center, or left side to left side? It sounds like outside to outside because shortening it allows more play, but I want to be 100% sure. Thank you again!

Hello Arne - do you have a pic of the 3.4 badge pls?
Thanks

Gap between slats.

http://forums.pelicanparts.com/uploa...1428508776.jpg

Oh okay! Then the info I need is the spacing of the mesh grille beneath, as well as the depth of the grille; how long the studs need to be. I'm planning on mounting the studs one behind the 3, one behind the 2

Thank you Arne!

I am interested in a 2.0 badge for my 912e
 

I am looking for a silver anodized 2.0 badge for my 912e and a silver anodized 3.2 badge for my Carrera both have plastic rear deck grills that will need pin mounts.

Andrew

Hi Andrew. Please email me at kyle@rebadge.com to place an order. Thank you!

On the plastic grill as used from the mid-70s through '89, the openings in the base mesh would allow anything from 1.0" to 2.0" spacing. So 1.5" spacing would allow the most flexibility. My badge from the previous maker has stud spacing of approx. 1.7" (as best I can eyeball it w/o dropping the A/C condenser).

Stud length should be .75-.85".

I received conflicting information. I was advised to space at 2.25" and use 1" studs.

I have two sizes of studs to use for future orders, so I will see how well received this first set up is. Thank you again!

Kyle, 2.25" w/1" studs should work fine. The 2.25" spacing would move the studs one hole farther apart than mine is, the only downside I can think of on that is it might lack the ability to fine-tune the position of the emblem horizontally on the grill. Would be a more positive fit, I suspect.

http://i36.photobucket.com/albums/e3...ps7brz3c7r.jpg
http://i36.photobucket.com/albums/e3...psbrwruv8s.jpg
http://i36.photobucket.com/albums/e3...psx9ugcvuw.jpg

Subscribed

Henry

Same here last year and never got it nor a refund either. I had luck here when someone sold me his extra badge.:confused:

Was this resolved and did you guys get your badges?

Perhaps I missed it, but what is the pricing for the badges with the studs.

Hi Alex, I'm not sure about their past vendor issues, but we started providing pieces since January [2015]. Badges are $125 plus shipping.

Thanks for your interest!
Kyle

I got in touch with Patrick Motorsports today, to see if they were planning to make the 3.2 badge (they have the 3.6 version on their website) and apparently they are going to do a batch of different numbers within the next few months. Their existing badges are $48, so I'm guessing they'll be in the same ballpark.

https://patrickms.s3.amazonaws.com/p...-Emblem-36.jpg

I was initially going to do the Patrick but thought these might have been a bit cheaper. They charge around 12$ for shipping but still decent price I suppose.

Kyle, I would like one of these 2.8 please. Thanks, Mark in ATL

grill badges
 

Any idea of whether these are still being made ?
Looks like the rebadge.com website is down....

Patrick motorsport only has 3.6 and 3.8 badges

Try to email kyle@rebadge.com. I got mine this time last year