DME TEMP SENSOR (Needed)

Dean924s · Dean924s's Garage

I need one for my MS project. The sensor that the blue plug on the harness plugs in to.

Here is a photo for reference.

Anyone have a working one lying around that they want to get rid of?

post up here or email me direct at dsmith@radio.fm

Thanks!!!!!

Dawgz83948 · Dawgz83948's Garage

They're available at ALL parts stores.

ernie9944 · ernie9944's Garage

For your car here on Pelican "BOSCH" part#944-606-125-00-M14 =$20.75

seafeye · 02-16-2012, 06:24 AM

How do you test it to see if it's good?

porsche8777 · 02-16-2012, 11:37 AM

Take an ohm meter and check it across the terminals. Cold should read about 3.4 kohms. Put tip in boiling water it shoul read about 200 ohms.

Dean924s · Dean924s's Garage

I was hoping to get one on the cheep. It will be for a one time use as I am running the final testing on the bending with a composer harnes.

seafeye · 02-16-2012, 05:00 PM

Quote:

bending with a composer harnes.

Huh?

ernie9944 · ernie9944's Garage

Quote:

Originally Posted by Dean924s

I was hoping to get one on the cheep. It will be for a one time use as I am running the final testing on the bending with a composer harnes.

Pelican will also supply you with a cheap one "brand FAE" #944-606-125-00-M323 cost $8.00.